Industrial worker blasting steel surface with recycled glass abrasive media

Get the right profile, the right finish, and the right coating adhesion — every time.

Steel surface preparation is the foundation of any coating system. A poorly prepared surface leads to premature coating failure, costly rework, and project delays. Recycled glass abrasive has become the go-to media for professionals who demand consistent, high-quality results without the risks of silica sand.

Why Steel Surface Preparation Matters

Goals include: removing rust, mill scale, old coatings, and contaminants; creating an anchor profile; meeting SSPC/NACE cleanliness standards; and achieving specified surface roughness.

Mesh Grade vs. Surface Profile

 

Mesh GradeProfile RangeBest Application
Coarse 10/205.2 milsHeavy rust, mill scale, thick coatings
Medium 20/403.2 milsGeneral steel prep, structural work
Fine 40/802.1 milsLight profiling, maintenance coating

Step-by-Step: Steel Surface Preparation with Recycled Glass

Step 1 — Select the Right Mesh Grade

Match your mesh to your coating system’s anchor profile specification using the table above.

Step 2 — Inspect and Stage the Steel

Remove grease, oil, and salts using solvent or detergent wash (SSPC-SP 1). Allow surface to dry completely. Mask areas not requiring blasting and ensure proper containment and ventilation.

Step 3 — Set Equipment Parameters

Nozzle pressure: 90–125 PSI. Nozzle size: 5/16″ to 3/8″ orifice. Nozzle distance: 6–12 inches from surface. Nozzle angle: 45–90 degrees. Use consistent overlapping passes.

Step 4 — Blast to Specification

SSPC-SP 6 / NACE 3 (Commercial Blast) for general industrial coatings. SSPC-SP 10 / NACE 2 (Near-White Blast) for high-performance coatings. SSPC-SP 5 / NACE 1 (White Metal Blast) for immersion service. Recycled glass abrasive efficiently achieves SP 10 and SP 5 ratings.

Step 5 — Inspect the Surface Profile

Use a profile gauge (Testex tape or digital profilometer) to measure Rz/Ra. Confirm cleanliness with SSPC visual standards. 

Step 6 — Apply Coating Promptly

Blasted steel oxidizes rapidly. Apply primer within 2–4 hours in humid conditions, or up to 8 hours in dry, controlled environments.

Zafa Glass Recommendations for Steel Prep

Primary (most applications): Medium Grade 20/40 mesh. Heavy rust/scale: Coarse Grade 10/20 mesh. Finishing coat prep: Fine Grade 40/80 mesh.

Get the right profile, finish, and coating adhesion with Zafa Glass recycled glass abrasive.

Contact us today for the best mesh grade for your project.
_

Comments are disabled.